Category Archives: Molding

Crown Molding Information

Until installing crown moulding, it’s important to know how to spot flaws. You’re curious about the low and high points on the wall and ceiling. When cutting the length of moulding you like, this might make a big difference. Some older homes have sags in the ceilings, which can be easily remedied by skim-coating the ceiling with joint compound or plaster after the moulding is built.Do you want to learn more? Visit restoration company.

When measuring, use a light pencil to draw a line across the room to indicate the location of the crown molding’s foot. Mark all of the stud positions as well, as this will aid you in aligning the moulding and firmly nailing it in place. Using putty to cover the nail holes, then sand it smooth and paint it after it has dried.

When cutting the mouldings, make sure the parts you’ve measured are slightly longer than what’s needed. This will ensure a tight fit and prevent you from making the expensive mistake of getting it too short. Also, due to the possible movement of walls and buildings, the moulding can pull apart, exposing the joints.

Corners may be difficult, but keep in mind that both sides must meet at a 45-degree angle. To get a flush corner, make one first, then tie the two pieces together and cover the mistake with a block. It might not look fantastic, but it will conceal the mistake.

Cutting the crown moulding requires precision, and this is often the most difficult aspect. Maintaining a record of which edge is the top and always picturing how it would look when nailed is a good tip for getting actual cuts.

Crown moulding comes in a variety of styles, so choose the ones that best fit your skill level. If you’re a novice, you may want to start with the peel and stick ones.

Note that crown moulding installation requires some skill, so study and practise with the equipment you’ll need for your project, and always remember that your protection comes first. Make the effort to watch crown moulding how-to videos; there are a multitude of them available online, and they’re a great way to learn about the tools, as well as tricks and tips of the trade.